Makeblock – Sterownik silnika krokowego

Description:

The Me Stepp er Driver V1.0 is a easy to use stepper motor driver board based on chip A4988, generally used to drive bipolar stepper motors precisely. It is perfect for 3D printing, CNC , Makeblock Music Robot as well as a lot of other applications where it’s necessary to control precise movement.

The A4988 is a complete microstepping motor driver with built-in translator for easy operation. It is designed to operate bipolar stepper motors in full-, half-, quarter-, eighth-, and sixteenth-step modes. Plus, we add a on-board DIP Switch and a on-board potentimeter, so you can change step modes and the current of motor easily.

Features:

• A4988 stepper driver chip
• Compatible with 4 wire bi-polar  stepper motors
• A potentiometer to control the current of the stepper motor
• A on-board DIP Switch(2 POS SIDE ACTUATED) support full, half, quarter, eighth, and sixteenth-step modes
• A buildin fuse protects board and chip from over current or any shortage by any reasons
• A on board heat sink helping  heat dissipation allows driver chip current up to 1.35A

easy  to use

• Comes with Arduino library for easy programing
• A power indicator
• Easy wiring with 6 Pin RJ11 interface
• Labeled with red tag and compatible with Me BaseBoard
• 2.54mm breakout pins for connecting with jumper wires
• 16mm interval M4 mounting holes, compatible with Makeblock beams

Specification:

• Max current: ±1.35A
• Max motor drive voltage: 25V

  Note: Me BaseBoard max supply  voltage 12V

• Logic voltage: 5V
• Dimensions: 48mm*24mm(Length × Width)

Part List:

1 x  Me Stepper Motor Driver V1.0

1 x  HT3.96-4P

1 x  heat sink

Documents:

• Arduino Library

For more details about this product, please visit Makeblock  wiki   page .  If you have any question about this product or you need technical support, please post it in Makeblock  forum.